 |
 |
 |
 |
 |
 |
This assembly tutorial is licensed under a Creative Commons Attribution-NonCommercial-NoDerivs 3.0 Unported License.
With this tutorial you'll be able to build the front center panel for a B737 flight simulator by using panels, parts and PCBs from Hispapanels.
You can find the needed parts here:
FRONT PANEL ASSEMBLY
We have to prepare the following panel previously:
We start preparing the annunciators. They are formed by one front engraved piece and two back pieces. Leds are parallel connected and each led is connected to a 470 ohms resistor:
We put hot glue and then paint the back side with black paint:
Pictures above show a basic way of installing the leds. You can use the PCBs for annunciators instead. The tutorial for these PCBs is here.
EThis video shows how to install the panel and the gear lever:
With this tutorial you'll be able to build a complete B737 Autobrakes by using panels, printed circuit board and components from Hispapanels. You can find the needed components to build the autobrakes panel by following these links:
And in this one how the panel is installed in the center module:
With this tutorial you'll be able to build a complete B737 flaps gauge by using panels, printed circuit board and components from Hispapanels. You can find the needed components to build the flaps gauge by following this link:
Here is shown how to build the gauge:
And here how to install it in the center module:
With this tutorial you'll be able to build a complete B737 yaw damper gauge by using panels, printed circuit board and components from Hispapanels. You can find the needed components to build the flaps gauge by following this link:
Here is shown how to build the gauge:
And here how to install it in the center module:
Last update: 02.11.2017
